anything major i need to do before sraying my bike?

and can i just remove stickers on fairing then spray or should i put a undercoat of somthing on first?

if you want a good finish your best sanding it all down with wet and dry they prime it then wet and dry the primer and then your base coat if it is metallic you will need lacquer to give it the shine or it will look dull. hope this helps

ok thax what should i sand it all down with?

as i dont have any machines or anything

oh and about my last post on rust problem i got rust on the seat screws.. its pritty bad and looks like they have lost there shape. what shell i do about them? i havnt tryed taking them off yes still waiting on the rust remover.

but what if they dont come off shell i just leave it and clean them up as good as possible?

you can buy some sort of tool to get old rusted bouts out of stuff have a look in homebase or b&q

yer think u can get sumin 2 get old screws out and 4 sprayin it just cleen it up key (dullen up) the surface and spray it u can also get a 3 in 1 paint which acts as a base color and laquer

and use wet and dry sandpaper

i manages to get some rust off my bike with WD-40 but there still lots on there on handle bars, bolts & frame. but ill get it off some how.

also another problem i have is a wobely brake lever... trouble is the screw with tightens it has been rounded off like all my other bolts Grrrr. dunno wat to do.

i managed to get rust off chain it was only light rust it just ran off.

buy sum cheep levers from a push bike shop can cost too much